As I wrote some months ago I finally have a wonderful Biotopus II by Elos, and after Aquatronica and Limulus is the third controller I own. As it is so different from the others, I could set it up on the wall… wonderful!

As normal for Elos the packaging is extremely well done, and in a very large package…



When I open it… it’s a wonderful sight, here you can watch it with every module I own



The Biotopus 2 is build also to be hanged to wall, because it has two hole in the back.

So I take the measures on the wall where to do the holes (and you can watch also the display of Aquatronica and Limulus over my intercom)



I’m drilling!!! Wow!!!

The result is absolutely perfect…

Firt test of positioning



And… my first difficulties. To be a perfect job, and to screw the Biotopus to the wall, so it will be impossibile that it could fall down… ready for my children…



And so you can watch the internal card f Biotopus II



After screwdriving the screws… the Biotopus is ready to work!

So I plug the power cord to the main unit under my aquarium… and all the probes.



… and the probes to the main unit



And I take a moment to watch all the job done



The last sight to all the cables, to assure (me) that everything it’s ready to go.
And the finally view after some hours of work. Near the main unit you can watch all the others my electronics devices



Any comments? Questions? What do you think about?

It’s obvious that the task has to be finished… this is only after the first day of work

Take a look, if you want, to all the pictures, that you can find here: http://www.danireef.com/2009/08/23/setting-on-the-wall-the-elos-biotopus-ii/